S5700-52C-SI-AC

Product Code

S5700-52C-SI-AC

Ports

48 × 10/100/1,000 Base-T

Extended Slots

2 extended slots, one for an uplink sub card and the other for a stack card.

Memory (RAM)

256 MB

Flash

32 MB

MAC Address Table Size

16 MAC

Subcard Supported

4 x 1,000 Base-X SFP subcard

2 x 10 GE SFP+ subcard

4 x 10 GE SFP+ subcard

Voltage Required

AC:

Rated voltage range: 100V to 240V, 50/60 Hz Maximum voltage range: 90V to 264V, 50/60 Hz

DC:

Rated voltage range: –48V to –60V, Maximum voltage range: –36V to –72V

Power Device

Double hot-swappable AC/DC power supplies

Power Consumption Operational

< 78W

Forwarding performance

132 Mpps

Switching capacity

256 Gbit/s 

Dimensions (W x D x H)

442 mm x 420 mm x 43.6 mm

Weight

7.4 kg

PoE

Not supported

①

Forty-eight 10/100/1000BASE-T ports

②

Front card slot

③

USB port

④

ETH management port

⑤

One console port

①

ESD jack

②

Rear card slot

③

Fan slot

④

Power module slot 2

⑤

Power module slot 1

Model

Description

GE-SFP Optical Transceiver

SFP-1000BaseT

Electrical Transceiver, SFP, GE, Electrical Interface Module(100m,RJ45)

eSFP-GE-SX-MM850

Optical Transceiver, eSFP, GE, Multi-mode Module(850nm,0.55km,LC)

SFP-GE-LX-SM1310

Optical Transceiver, eSFP, GE, Single-mode Module(1310nm,10km,LC)

S-SFP-GE-LH40-SM1310

Optical Transceiver, eSFP, GE, Single-mode Module(1310nm,40km,LC)

S-SFP-GE-LH40-SM1550

Optical Transceiver, eSFP, GE, Single-mode Module(1550nm,40km,LC)

10G-SFP+ Optical Transceiver

SFP-10G-USR

10GBase-USR Optical Transceiver,SFP+,10G,Multi-mode Module(850nm,0.1km,LC)

OMXD30000

Optical Transceiver,SFP+,10G,Multi-mode Module(850nm,0.3km,LC)

OSX010000

Optical Transceiver,SFP+,10G,Single-mode Module(1310nm,10km,LC)

Models

S5700-52C-SI

S5700-52C-SI-AC

S5700-52C-PWR-SI

Fixed Ports

48 x 10/100/1,000 Base-T

48 x 10/100/1,000 Base-T

48 x 10/100/1,000 Base-T

Extended Slots

2 extended slots, one for an uplink subcard and the other for a stack card

2 extended slots, one for an uplink subcard and the other for a stack card

2  extended slots, one for an uplink subcard and the other for a stack card

Power Supply

Double hot-swappable AC/DC

Double hot-swappable AC/DC

Double hot-swappable AC,  PoE+

Forwarding Performance

132 Mpps

 132 Mpps

132 Mpps

Switching Capacity

256 Gbit/s 

  256 Gbit/s 

256 Gbit/s 

Power Consumption

< 78W

< 78W

(PoE: 740W)

S5700-52C-SI-AC Specification

MAC address table

-IEEE 802.1d compliance

-MAC address learning and aging

-Static, dynamic, and blackhole MAC address entries

-Packet filtering based on source MAC addresses

MAC address entries: 
-S5700S-LI series: 8K,
-S5700-LI/S5700-SI series: 16K,
-S5700-EI series: 32K,
-S5720-EI series: 64K,
-S5700-HI series: 32K,
-S5710-HI: 456K,
-S5720-HI: 128K

VLAN

-4K VLANs

-Guest VLAN and voice VLAN

-GVRP

-MUX VLAN

-VLAN assignment based on MAC addresses, protocols, IP subnets, policies, and ports

-1:1 and N:1 VLAN Mapping

-Super VLAN(supported by the S5700-SI/S5700-EI/S5700-HI series)

Ring protection

-RRPP ring topology and RRPP multi-instance

-Smart Link tree topology and Smart Link multi-instance, providing the millisecond-level protection switchover

-SEP

-ERPS(G.8032)(supported by the S5700-LI/S5700-SI/S5700-EI/S5700-HI series)

-STP, RSTP, and MSTP

-BPDU protection, root protection, and loop protection

-BPDU Tunnel

Reliability

-Ethernet OAM (IEEE 802.3ah and 802.1ag)

-ITU-Y.1731

-DLDP

-LACP

-E-Trunk(supported by the S5700-SI/S5700-EI/S5700-HI series)

-BFD for OSPF, BFD for IS-IS, BFD for VRRP, and BFD for PIM (supported by the S5700-EI/S5700-HI series)

MPLS features

-MPLS L3VPN

-MPLS L2VPN(VPWS/VPLS)

-MPLS-TE

-MPLS QoS

Notes: supported by S5710-EI, S5700-HI and S5710-HI

IP routing

-Static routing

-RIPv1, RIPv2 and RIPng,ECMP(supported by the S5700-SI/S5700-EI/S5700-HI series)

-OSPF, OSPFv3, IS-IS, IS-ISv6, BGP and BGP4+ (supported by the S5700-EI/S5700-HI series)

IPv6 features

-Neighbor Discovery (ND)

-Path MTU (PMTU)

-IPv6 ping, IPv6 tracert, and IPv6 Telnet

-ACLs based on the source IPv6 address, destination IPv6 address, Layer 4 ports, or protocol type

-MLD v1/v2 snooping

-6to4 tunnel, ISATAP tunnel, and manually configured tunnel(supported by the S5700-SI/S5700-EI/S5700-HI series)

Multicast

-IGMP v1/v2/v3 snooping and IGMP fast leave

-Multicast forwarding in a VLAN and multicast replication between VLANs

-Multicast load balancing among member ports of a trunk

-Controllable multicast

-Port-based multicast traffic statistics

-IGMP v1/v2/v3, PIM-SM, PIM-DM, PIM-SSM, MSDP (supported by the S5700-EI/S5700-HI series)

QoS/ACL

-Rate limiting on packets sent and received by an interface

-Packet redirection

-Port-based traffic policing and two-rate three-color CAR

-Eight queues on each port

-WRR, DRR, SP, WRR+SP, and DRR+SP queue scheduling algorithms

-WRED (supported by the S5710-EI and S5700-HI)

-Re-marking of the 802.1p priority and DSCP priority

-Packet filtering at Layers 2 through 4, filtering out invalid frames based on the source MAC address, destination MAC address, source IP address, destination IP address, TCP/UDP port number, protocol type, and VLAN ID

-Rate limiting in each queue and traffic shaping on ports

Security

-User privilege management and password protection

-DoS attack defense, ARP attack defense, and ICMP attack defense

-Binding of the IP address, MAC address, interface, and VLAN

-Port isolation, port security, and sticky MAC

-MFF

-Blackhole MAC address entries

-Limit on the number of learned MAC addresses

-802.1x authentication and limit on the number of users on an interface

-AAA authentication, RADIUS authentication, HWTACACS authentication, and NAC

-SSH v2.0

-Hypertext Transfer Protocol Secure (HTTPS)

-CPU defense

-Blacklist and whitelist

Access Security

DHCP Relay, DHCP Server, DHCP Snooping, DHCP Security

Management and maintenance

-Virtual cable test

-Port mirroring and RSPAN (remote port mirroring)

-Remote configuration and maintenance using Telnet

-SNMP v1/v2c/v3

-RMON

-Web NMS

-HGMP

-System logs and alarms of different levels

-802.3az EEE (supported by the S5700(S)-LI, S5710-EI, S5700-HI and S5710-HI)

-Dying gasp (supported by the S5700-HI, S5710-HI and S5700(S)-LI(except battery LAN switches)

-NetStream (supported by the S5710-EI, S5700-HI and S5710-HI)

-sFlow(supported by the S5700(S)-LI/S5700-EI/S5700-HI series)

Interoperability

-Supports VBST (Compatible with PVST/PVST+/RPVST)

-Supports LNP (Similar to DTP)

-Supports VCMP (Similar to VTP)

Operating environment

Operating temperature: 0℃–50℃

Relative humidity: 10%–90% (non-condensing)

Input voltage

AC:

-Rated voltage range: 100 V to 240 V AC, 50/60 Hz

-Maximum voltage range: 90 V to 264 V AC, 47/63 Hz

DC:

-Rated voltage range: –48 V to –60 V, DC

-Maximum voltage range: –36 V to –72 V DC

Note: PoE-support switches do not use DC power supplies.